Inhaltsverzeichnis   MOBOTIX Online-Hilfe

Assign wires

The dialogue assign wires lets you enter how the camera and its expansion hardware is connected.

Door station cameras use this information to handle display and control of standard inputs and outputs transparently. Even if you are not using your camera as a door station, the connections you specify here can be used via ISDN and VoIP calls to or from the camera, MxEasy, or the iPad-App.

Inputs

The state of the following inputs can be visualised, if they are entered correctly:

Input Description
Door Position Contact If you use a Door Position Contact, the applications can display whether the door is open or closed.
Bolt Position Contact If you use a Bolt Position Contact, the applications can display whether the door is locked.

Outputs

The following outputs can be switched, if they are entered correctly:

Output Description
Door Release Actuator This output can be activated to admit guests via the door station. You can provide a switch time in case the distance from the door station to the door is greater than usual.
Note: Please note that many Door Release Actuators are not constructed for permanent use, and may burn out if they are activated for too long. The MOBOTIX Security Door Opener restricts the switch time to ten seconds for this reason.
In audio phonhe calls to the camera, this function is accessible via signal out action A on key 1.
Lights The light switch connected to this output can illuminate the cameras environment or the entrance area of the building. This output can be switch permanently, or triggered for the specified duration.
In audio phonhe calls to the camera, this function is accessible via signal out action C on key 3.
Internal Lights Only available on Door Stations! THis output should be connected to the MOBOTIX Info Module. It is used to enable the camera to control the module's backlight in accordance with its own.

Bells

Only available on Door Stations!

Make a selection of inputs or camera buttons to be used as bells. These bells can be assigned to receivers during the set-up. It is advisable to enter names based on the position of the bell, e.g. for a triple bell module "Bell_Top", "Bell_Middle", Bell_Bottom". This facilitates later identification of the bells after several changes of configuration.

Negation

All inputs and outputs can be negated, This function is needed, when the attached devices do not behave as expected, and are therefore incorrectly displayed or controlled by the camera.

Usually it should be unneccessary to change this.


Konfiguration sichern

Klicken Sie auf Setzen, um die Einstellungen zu aktivieren und bis zum nächsten Neustart der Kamera zu sichern.

Klicken Sie auf Voreinstellung, um diesen Dialog auf die werkseitigen Voreinstellungen zurückzusetzen (dieser Button wird nicht in allen Dialogen angezeigt).

Klicken Sie auf Zurückholen, um alle Änderungen seit dem letzten permanenten Speichern der Konfiguration zu verwerfen.

Beenden Sie den Dialog durch Klick auf Schließen. Hierbei wird geprüft, ob Änderungen der Gesamtkonfiguration vorliegen. Ist dies der Fall, werden Sie gefragt, ob die Gesamtkonfiguration dauerhaft gesichert werden soll.

cn, de, en, es, fr, it, jp, ru

© 2001-2024 MOBOTIX AG, Germany · http://www.mobotix.com/